Presented in Partnership with:

Ask the Expert Question-and-Answer Archive
(Hard Chrome Plating)

by Randy Taylor, Advanced Tooling Corporation.
August, 2006

Chrome Plating Over a Rough Surface

Q. How does the initial surface roughness effect the outcome of chrome plating? Does it depend on the thickness of the plating? What about surface peaks and valleys -- will the coating always follow the peak and valley or does it smooth them out?

A. Chrome plating does not smooth out peaks & valleys. Nor will it hide scratches or nicks by itself.

For decorative chrome, parts are polished, then coated with a build layer of bright nickel or bright copper/nickel to fill and level peaks & valleys prior to applying the final thin "cap" layer of chrome (0.000020 - 0.000040 thick) hence the bright finish.

For hard chrome, base metal should be ground, smooth, uniform, with no sharp edges. Typically, pre-treatment includes polishing, shot peening, glass bead and/or grit blasting before plating. In the plating process, first step is usually a reverse current chemical etch to enhance adhesion. Evidence of all these pre-treatments can be visible in the finished layer of hard chrome, but is seldom a cause for rejection. Thicknesses ranges from 0.0003 to unlimited.

No substitution for proper base metal preparation in chrome plating. "Chrome is a mirror or what's underneath"




The information contained in this site is provided for your review and convenience. It is not intended to provide legal advice with respect to any federal, state, or local regulation.
You should consult with legal counsel and appropriate authorities before interpreting any regulations or undertaking any specific course of action.

Please note that many of the regulatory discussions on STERC refer to federal regulations. In many cases, states or local governments have promulgated relevant rules and standards
that are different and/or more stringent than the federal regulations. Therefore, to assure full compliance, you should investigate and comply with all applicable federal, state and local regulations.