Presented in Partnership with:

Ask the Expert Question-and-Answer Archive
(Hard Chrome Plating)

by Larry Zitko, ChromeTech, Inc.
August, 2002

Chromium Plating Efficiency

Q. I'm a student doing some general research on chrome electroplating. My question is, on average, what percentage of the chrome used in the plating process actually gets plated on the substrate? What percentage of the chrome is left over for waste water or sludge on average?

A. The numbers are difficult to estimate due to the many variations in the designs of the hard chrome plating equipment and the techniques employed by the plating operators. Let me explain.

Some facilities still send chromium-bearing rinse water (from rinse tanks) and chromium-bearing fluid from air pollution control devices to their waste treatment system. In this situation, the amount of chromium waste can be hundreds or thousands of pounds per year. Modern hard chrome facilities are often designed with waste minimization and pollution prevention goals in mind. All rinse water can be reclaimed to the plating tanks, as well as all wash down fluid from the air scrubbers, if they are dedicated. In this case, the only chromium existing the system may be the controlled air emission exiting the stack, as low as 5 lb. / year or less as . Hard chrome plating lends itself well to reclaiming these fluids because the bath is quite forgiving of contaminants and its high operating temperature (115-150 deg. F.) evaporates a lot of water vapor.

The rate at which chromium is dragged out of the plating tank and into the rinse tank can vary significantly (1 gal to 10 gal or more per 1,000 ft2 plated) depending upon part shapes, racking design and operator techniques during rinsing.

Modern composite meshpad mist eliminators used for extracting entrained chromium from exhaust air streams are highly efficient, often 99.8% eff. or higher.




The information contained in this site is provided for your review and convenience. It is not intended to provide legal advice with respect to any federal, state, or local regulation.
You should consult with legal counsel and appropriate authorities before interpreting any regulations or undertaking any specific course of action.

Please note that many of the regulatory discussions on STERC refer to federal regulations. In many cases, states or local governments have promulgated relevant rules and standards
that are different and/or more stringent than the federal regulations. Therefore, to assure full compliance, you should investigate and comply with all applicable federal, state and local regulations.