Ask the Expert Question-and-Answer Archive
(Hard Chrome Plating)

by Larry Zitko, ChromeTech, Inc.
May, 2002

Sources of Technical Information on Chromium Plating

Q. I would like to know where could I get some information about the mechanism of chromium plating, concerning the Helmholtz double layer and the difusion layer. I would like some books or literature about it. Thank you very much

A. Here are some sources for you: 1) N.V. Mandich, "Chemistry & Theory of Chromium Deposition: Part II - Theory of Deposition", Plating and Surface Finishing Magazine, p.108 (May. 1997).

2) N.V. Mandich, "Chemistry & Theory of Chromium Deposition: Part II - Theory of Deposition", Plating and Surface Finishing Magazine, p.97 (Jun. 1997).

3) L.E. Vaaler, M.F. El-Shazly and E.W. Brooman, "High-Speed Chromium Plating Using Enhanced Mass Transfer", Plating and Surface Finishing Magazine, p.50 (Aug. 1987).

Item 2 is the most extensive and technical in nature.

 

 


The information contained in this site is provided for your review and convenience. It is not intended to provide legal advice with respect to any federal, state, or local regulation.
You should consult with legal counsel and appropriate authorities before interpreting any regulations or undertaking any specific course of action.

Please note that many of the regulatory discussions on STERC refer to federal regulations. In many cases, states or local governments have promulgated relevant rules and standards
that are different and/or more stringent than the federal regulations. Therefore, to assure full compliance, you should investigate and comply with all applicable federal, state and local regulations.